C.T.M. 7 Series 지침 책자 - 페이지 12

{카테고리_이름} C.T.M. 7 Series에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. C.T.M. 7 Series 17 페이지.

7-Series

ASSEMBLING YOUR SCOOTER

To assemble the scooter, you can repeat the disassembly directions in reverse.

Abbreviated directions are given below. Refer to the Figures on pages 11 - 12 to

locate the parts.

1.Use the tiller angle adjustment lever to move the steering column up out of the way.

2.Place the front basket

3.Tilting the rear end to a horizontal position, insert the scooter frame tube of the front

end into the rear section first, making sure that the locking pins are removed.

4.Slide the two sections of the unit together until the front half reaches its limits.

5.Insert the two locking pins into their corresponding holes. Both locking pins must be

fully inserted whenever the scooter is assembled.

6.Place batteries, one on each side of the seat post, and use Vel-cro to fix the position.

7.Attach the battery power plugs.

8.Attach the wire connect.

9.Place rear hood, battery cover and free-wheeling knob.

10.Loosen Seat Rotation Lever counterclockwise. Place seat on seat post. Tighten Lever

again by turning clockwise. Lock Seat Control Lever on bottom of seat before sitting

down.

Instruction Booklet