C.T.M. HS-666 지침 책자 - 페이지 11
{카테고리_이름} C.T.M. HS-666에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. C.T.M. HS-666 19 페이지. 6-series
페이지 인쇄
- 1. Table of Contents
- 2. Introduction
- 3. Important Precautions
- 4. Electromagnetic Interference and Warnings
- 5. Identification of Parts
- 6. Operating Your Scooter
- 7. Assembling Your Scooter
- 8. Disassembling Your Scooter
- 9. Charging the Batteries
- 10. Care and Maintenance
- 11. Troubleshooting
- 12. Technical Specifications
6-Series
ASSEMBLING YOUR SCOOTER
No tools are necessary. A screwdriver is needed to adjust seat height after assembly.
To assemble C.T.M. Mobility Scooter you should have the three scooter parts : front.
section, rear section and seat. You will also need two batteries and a battery charger.
Follow these steps:
Use the Tiller Angle Adjustment Lever to move the Tiller Angle Adjustment up out of the
way.(See Fig. 3)
Connect front and rear sections by linking latching hook (A) to pin (B).(See Fig. 4)
Pluging the two wire connectors (C)between the front and rear sections.(See Fig. 5)
Place batteries, one on each side of the seat post.(See Fig. 6)
Attach the power plugs (D).(See Fig. 7)
A
B
Figure 4
Figure 4
Figure 6
Figure 6
9
Instruction Booklet
Figure 3
Figure 3
C
Figure 5
Figure 5
D
Figure 7
Figure 7