C.T.M. HS-850 지침 책자 - 페이지 8

{카테고리_이름} C.T.M. HS-850에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. C.T.M. HS-850 17 페이지. Mobility scooter 8-series
C.T.M. HS-850에 대해서도 마찬가지입니다: 서비스 매뉴얼 (15 페이지)

페이지 인쇄

8-Series

FUNCTION OF PARTS

TOP CONTROL PANEL

Speed Dial Knob

The Rabbit means fast and Turtle is slow. By turning this you control total speed

transferred to thumb controls.

Battery Gauge

There is a meter shows batteries capacity status.

ADJACENT TO TOP CONTROL PANEL

Thumb Lever

Pushing right thumb lever moves scooter forward. Pushing left thumb lever moves the

scooter backward. (This can be reversed if required by local dealer.) Releasing both,

engages automatic brake. These are also your accelerator. The further you depress

them, the faster you go. (Subject to the position of the Rabbit/Turtle control).

AT BASE OF STEERING TILLER

Tiller Angle Adjustment

Pull downward the tiller adjustment to adjust tiller angle and release to lock at

comfortable position.

BELOW SEAT

Seat Height Adjuster

There are three holes on seat tube to adjust seat height. Be sure the detent pin is fully

inserted at its new height before sitting.

Armrest width Adjustment Thumbscrews

Loosen the two thumbscrews to adjust arm width; tighten again to lock in at desired

position.

Legroom Adjuster

There are few holes on front and rear frame tube for adjusting legroom. Pull the toggle

latch to loosen and insert the detent pin to locate the position. Push the toggle latch

again to lock.

REAR BODY

Rear Compartment Cover

Open the compartment Cover to access on board charger.

Anti-tip wheels

Helps keep scooter from tipping over.

Free-Wheeling Lever

When lever is in N (Neutral) position, scooter can be moved without power.

When lever is in D (Drive) position, scooter can be driven. Normal position is D.

Instruction Booklet