Acdeos AXS MD SA Series 요약된 매뉴얼 - 페이지 6

{카테고리_이름} Acdeos AXS MD SA Series에 대한 요약된 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acdeos AXS MD SA Series 13 페이지.

Always try to go as vertically as possible straight up from

the fixing point on the rear of the step to the fixing points

on the vehicles floor.

Adjust the step so that it is horizontal under the vehicle.

Finally fit all bolts and nuts to complete the mounting of the

step.

You can adjust the height of the step under the vehicle by

adjusting the front brackets in the slot holes.

4.2

Mechanical adjustment

The step is being pushed out by two helical springs. The force at the springs can be adjusted

at a installed step under the vehicle.

There are two preload adjusters at the bottom plate of the step. To adjust the load, bring the

step in "out" position. Lose the two M8 bolts a little. Remove the two locking screws. Place a

6 mm hex key in the hex hole and adjust the load to plus or minus. After adjusting fix the

locking screws and M8 bolts. Both sides need to be in the same position after adjustment.

Remove

Lose a bit

4.3

The step comes standard without cable loom, only with a simple close switch. A wiring loom

should be made according schedule in appendix 1.

Optional original cable loom including connector fuse and dashboard LED is available under

number S130 000 Ask your dealer for availability

Pls note that a safety Light at the dashboard in sight of the driver is strongly recommended

and in some countries legally required.

The connector used at the step is of the type AMP Super seal 2 pole male C 282080-1

The counter part is AMP SUPERSEAL 2 Way, 1 Row Female Connector Housing 282104-1

Remove

Lose a bit