Cisco N540X-8Z16G-SYS-A 설치 준비 - 페이지 8
{카테고리_이름} Cisco N540X-8Z16G-SYS-A에 대한 설치 준비을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco N540X-8Z16G-SYS-A 14 페이지.
Cisco N540X-8Z16G-SYS-A에 대해서도 마찬가지입니다: 매뉴얼 (30 페이지)
페이지 인쇄
Tools and Equipment
Also consider any additional interface equipment you need, such as transceivers, hubs, switches, modems,
Channel Service Units (CSU), or Data Service Units (DSU).
Before you install the router, have all the additional external equipment and cables on hand. For information
about ordering, contact a Cisco customer service representative.
The extent of your network and the distances between the network interface connections depend, in part, on
the following factors:
• Signal type
• Signal speed
• Transmission medium
The distance and rate limits referenced in the following sections are the IEEE-recommended maximum speeds
and distances for signaling purposes. Use this information as a guideline when planning your network
connections prior to installing the router.
If wires exceed the recommended distances, or if wires pass between buildings, give special consideration to
the effect of a lightning strike in your vicinity. The electromagnetic pulse caused by lightning or other
high-energy phenomena can easily couple enough energy into unshielded conductors to destroy electronic
devices. If you have had problems of this sort in the past, you may want to consult experts in electrical surge
suppression and shielding.
Tools and Equipment
You need the following tools and equipment to install and upgrade the device and its components:
• ESD-preventive cord and wrist strap
• Antistatic mat or antistatic foam
• Number 1 and Number 2 Phillips-head screwdrivers
• #12-24 pan-head screws to secure the device to the equipment rack
• Cables for connecting to network ports (based on the configuration)
• Ethernet hub, switch, or PC with a network interface card for connecting to the Ethernet ports
• Console terminal that is configured for 115200 baud, 8 data bits, no parity, no flow control, and 2 stop
• Console cable for connecting to the console port
• Ratcheting torque screwdriver with a Phillips head that exerts up to 30-pound force per square inch
• Crimping tool as specified by the ground lug manufacturer
• Wire-stripping tools for stripping both 6 and 14-AWG wires
• Tape measure and level
• Ratcheting torque screwdriver with a Phillips head that exerts up to 15 inch-pounds (1.69 newton meters)
Prepare for Installation
8
bits
(0.02-kilograms force per square millimeter (kgf/mm2)) of pressure
of torque for attaching the ground wire to the device
Prepare for Installation