CAB EOS2 운영자 매뉴얼 - 페이지 9
{카테고리_이름} CAB EOS2에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB EOS2 15 페이지.
CAB EOS2에 대해서도 마찬가지입니다: 서비스 매뉴얼 (20 페이지)
![CAB EOS2 운영자 매뉴얼](/uploads/products/server2/555044/555044.jpg)
3
Operation
3.1 Loading Material
Fold down the cutter.
Insert labels for tear-off mode Operator's manual of the printer.
Place the media strip between the printhead and the drive roller, so that
the front edge of the strip reaches through the cutter.
Figure 3
Guiding the labels into the cutter
Guide the labels (2) into the slot (1) and fold up the cutter.
Insert ribbon Operator's manual of the printer.
3.2 Reference to the Programming
Activate the cut mode in the software.
In direct programming use the "C" command.
Programming Manual of the printer.
Configure the cut parameters 4. Printer Configuration
i
Note!
The cut parameters are only accessible with cutter installed.
1
2
9