CAB EOS5 서비스 매뉴얼 - 페이지 13

{카테고리_이름} CAB EOS5에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB EOS5 20 페이지.
CAB EOS5에 대해서도 마찬가지입니다: 운영자 매뉴얼 (15 페이지)

Replacing Assembly Units

2.8

Replacing the Printhead Holder

Fig. 9

Removing / mounting printhead holder

Removing

 Remove the casing.

 Remove the printhead.

 Remove the spring (2) from the spring bolt (1).

 Lift the printhead holder (7), unlock the latch (4) and push the printhead holder with the spring (2) to the operator's

side out of the chassis (3).

 Remove the printhead holder (7) with the spring (2) completely from the retainer (6). In doing so remove the

printhead cable (8) from the printhead holder.

 Keep the spring (2).

Mounting

 Push the printhead holder (7) onto the retainer (6). In doing so insert the printhead cable (8) into the printhead

holder.

 Push latch (4) and spring hook (5) of the printhead holder through the gap of the chassis (3).

Note!

For the following mounting of the spring (2) it is recommended to push the printhead holder in a position,

where the latch (4) is clamped by the chassis but not completely locked yet.

 Mount the spring (2) onto the spring hook (5).

 Push the printhead holder (7) further until the latch (4) clicks into place.

 Mount the spring (2) onto spring bolt (1).

 Mount the printhead.

 Mount the casing.