Cisco NCS 55A2-MOD-HD-S 매뉴얼 - 페이지 4

{카테고리_이름} Cisco NCS 55A2-MOD-HD-S에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco NCS 55A2-MOD-HD-S 25 페이지. Connect router to the network

Create the Initial Router Configuration

Step 3

Attach the other end of the cable to the console port.

Table 1: RJ-45 Straight-through Cable Pin-outs

RJ-45 Pin

Create the Initial Router Configuration

You must assign an IP address to the router management interface so that you can then connect the router to

the network.

When you initially power up the router, it boots up and asks a series of questions to configure the router. To

enable you to connect the router to the network, you can use the default choices for each configuration except

for the IP address, which you must provide.

Note

Be aware of the router's unique name to identify it among the devices in the network.

Before you begin

• A console device must be connected with the router.

• The router must be connected to a power source.

• Determine the IP address and netmask needed for the Management interfaces:

Step 1

Power up the router.

The LEDs on each power supply light up (green) when the power supply units are sending power to the router, and the

software asks you to specify a password to use with the router.

Connect Router to the Network

and

MgmtEth0/RP1/CPU0/0

Connect Router to the Network

Signal

—

Ground (GND)

GND

—

MgmtEth0/RP0/CPU0/0