Cisco NCS 6000 매뉴얼

{카테고리_이름} Cisco NCS 6000에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco NCS 6000 27 페이지.

Installing the Power Components

This chapter provides an overview of the AC and DC power systems and how to install the power modules

and input power cables into the Cisco NCS 6000 Fabric Card Chassis (FCC). For information about removing

power components, see the

•

Power System Overview

The Cisco NCS 6000 FCC can be configured with either an AC input power system or a DC input power

system. Site power requirements differ, depending on the source voltage used.

For information about power safety requirements, see the

the Cisco Network Convergence System 6000 Series Routers.

Prerequisites

Follow these precautions and recommendations when planning power connections to the FCC:

• Check the power at your site before installation to ensure that you are receiving clean power (free of

• Install proper grounding to avoid damage from lightning and power surges.

Installing the Fabric Card Chassis Ground Cable

The FCC has two safety earth ground connections. You can connect the central office ground system or interior

equipment grounding system to either of these grounding points on the rear side of the FCC. One chassis

ground is located near the top of the FCC and one chassis ground is located at the bottom of the FCC. These

Removing the Power Components

Power System Overview, page 1

Installing the Power Modules and Input Power Cables, page 11

Powering On and Powering Off the Fabric Card Chassis, page 23

spikes and noise). Install a power conditioner, if necessary.

Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide

section.

Regulatory Compliance and Safety Information for