Cisco NCS 6008 매뉴얼 - 페이지 5

{카테고리_이름} Cisco NCS 6008에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco NCS 6008 12 페이지. 6000 series network convergence system routers unpacking, moving, and securing guide
Cisco NCS 6008에 대해서도 마찬가지입니다: 포장 풀기, 이동 및 고정 매뉴얼 (44 페이지)

페이지 인쇄

Bring-up the Cisco NCS 6008 Router

Step 4

config

Example:

sysadmin-vm:0_RP0#config

Enters System Admin Config mode.

Step 5

(Optional) exit

Example:

sysadmin-vm:0_RP0#exit

Return to the XR VM CLI from the System Admin VM CLI.

Alternate Method to Access the System Admin VM

Instead of executing the admin command, you can access the System Admin prompt by directly

connecting to the System Admin VM console port. Console port 1 on the RP is for System Admin

VM. While connecting to the System Admin VM console port, enter the System Admin username

and password, when prompted. For more details about System Admin VM username and password,

see the chapter

Important

It is not possible to access the XR VM through the System Admin VM console port.

Configure the XR VM Management Port

To use the XR VM Management port for system management and remote communication, you must configure

an IP address and a subnet mask for the management ethernet interface. To communicate with devices on

other networks (such as remote management stations or TFTP servers), you need to configure a default (static)

route for the router .

Before you begin

• Consult your network administrator or system planner to procure IP addresses and a subnet mask for the

• Physical port Ethernet 0 on RP is the management port. Ensure that the port is connected to management

SUMMARY STEPS

1. configure

2. interface MgmtEth rack/slot/CPU0/port

3. ipv4 address ipv4-address subnet-mask

4. ipv4 address ipv4 virtual address subnet-mask

5. no shutdown

Create User Profiles and Assign

management interface.

network.

Configure the XR VM Management Port

Privileges.

Bring-up the Cisco NCS 6008 Router