Cisco Network Convergence System 6000 Series 포장 풀기, 이동 및 고정 매뉴얼 - 페이지 20
{카테고리_이름} Cisco Network Convergence System 6000 Series에 대한 포장 풀기, 이동 및 고정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Network Convergence System 6000 Series 44 페이지. 6000 series network convergence system routers unpacking, moving, and securing guide
페이지 인쇄
Dolly Specifications
Figure 1-7
Swing the lift arm swing bracket to the side (180-degree position as shown in
Step 6
holding bolts and partially tighten the bolts.
Repeat Step 1 through Step 6 for the other dolly unit.
Step 7
configuration.
Step 8
Lock the dolly caster brakes and anti-rotation pins until you are ready to move the chassis.
Step 9
Using the 3/8-inch ratchet wrench with 12-mm hex bit, firmly tighten the holding bolts on both dolly
units.
Note
Cisco Network Convergence System 6000 Series Routers Unpacking, Moving, and Securing Guide
1-12
Chassis Dolly—Removing Holding Bolts and Swinging Arm Out to 180-Degrees
To change the configuration back to the 90-degree configuration, repeat these steps and swing
the arm into the 90-degree position.
Figure
Figure 1-6
shows the dolly in a 180-degree
Chapter 1
1-7). Reinsert the
OL-29233-01