Cisco Network Convergence System 6000 Series 포장 풀기, 이동 및 고정 매뉴얼 - 페이지 37
{카테고리_이름} Cisco Network Convergence System 6000 Series에 대한 포장 풀기, 이동 및 고정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Network Convergence System 6000 Series 44 페이지. 6000 series network convergence system routers unpacking, moving, and securing guide
페이지 인쇄
Chapter 3
To reduce the risk of dolly instability, chassis damage, or personal injury, do not raise the equipment
Warning
more than 1 inch (2.4 cm) above the floor during transportation. Statement 358
This dolly is designed to transport the equipment over short distances only. Statement 359
Warning
Warning
In order to reduce the risk of chassis damage or personal injury when replacing a fully-loaded,
existing chassis, do not move the chassis in a configuration that is greater than the as-shipped
chassis. Before attaching the dolly and moving the chassis, remove the power system, fan trays, RP
cards, FCs, and LCs from the chassis. Statement 367
Warning
To reduce the risk of dolly instability, chassis damage, or personal injury, do not transport the
equipment with the dolly raised higher than the maximum transport height shown on the dolly label,
and do not raise the equipment higher than required to remove the shipping pallet. For information
about maximum dolly heights, see the dolly instructions in this document. Statement 368
Dolly wheel casters and anti-rotation pins should be in the locked position when the dolly is not in use.
Caution
Verifying the Move Path
Before moving the chassis, it is critical that you verify that the path that you are planning to use to move
the chassis to its final location can accommodate the chassis size and weight and the restrictions of the
chassis when using the dolly.
See
for the entire move path prior to moving the chassis.
Table 3-1
Specification
Height (on dolly, with recommended 1 inch raise)
Depth (on dolly, 90-degree dolly position)
Depth (on dolly, 180-degree dolly position)
Width (on dolly, 90-degree dolly position)
Width (on dolly, 180-degree dolly position)
Weight of chassis (as shipped, packaging removed)
Weight of dolly
Maximum recommended height from floor
(for chassis on dolly)
OL-29233-01
Table 3-1
for a list of the restrictions for your move path, and verify that you have sufficient room
Cisco NCS 6008 Chassis Move-Path Specifications
Cisco Network Convergence System 6000 Series Routers Unpacking, Moving, and Securing Guide
Verifying the Move Path
Value
82 in. (208.3 cm)
70 in. (178 cm)
48 in. (122 cm)
23.6 in. (60 cm)
44 in. (112 cm)
775 lb (352 kg)
126 lb (57.3 kg)
1.5 in. (3.8 cm)
3-3