Cisco Nexus 1000V 배포 매뉴얼 - 페이지 45
{카테고리_이름} Cisco Nexus 1000V에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Nexus 1000V 49 페이지. For microsoft hyper-v
Cisco Nexus 1000V에 대해서도 마찬가지입니다: 데이터시트 (8 페이지), 배포 매뉴얼 (25 페이지), 매뉴얼 (6 페이지), 설치 매뉴얼 (27 페이지)

Links within the PortChannel that are connected to the same physical switch are bundled in the same subgroup
automatically through the use of the Cisco Discovery Protocol packets received from the upstream switch.
Alternatively, interfaces can be manually assigned to a specific subgroup using interface-level configuration.
When vPC-HM is used, each vEth interface on the VEM is mapped to one of the two subgroups using a round-
robin mechanism. All traffic from the vEth interface uses the assigned subgroup unless the assigned subgroup is
unavailable, in which case the vEth interface will fail over to the remaining subgroup. When the originally assigned
subgroup becomes available again, traffic will shift back to its original location. Traffic from each vEth interface is
then hashed within its assigned subgroup based on the configured hashing algorithm.
When multiple uplinks are attached to the same subgroup, the upstream switch needs to be configured in a
PortChannel, bundling those links together. The PortChannel needs to be configured with the option mode on.
Figure 37.
Virtual PortChannel Host Mode
Load Balancing
The Cisco Nexus 1000V provides 17 hashing algorithms to load-balance traffic across physical interfaces in a
PortChannel. These algorithms can be divided into two categories: source-based hashing and flow-based
hashing. The type of load balancing that the Cisco Nexus 1000V uses can be specified in VEM-level detail, so one
VEM can implement flow-based hashing, using the better load sharing offered by that mode, and another VEM not
connected to a clustered upstream switch can use MAC address pinning and thus source-based hashing.
Choose the hashing algorithm used with care because it affects the available configuration options and may
require configuration changes on the access-layer switches. The default hashing algorithm used by the Cisco
Nexus 1000V is source MAC address hashing (a source-based hash).
Source-Based Hashing
Source-based hashing algorithms help ensure that a MAC address is transmitted down only a single link in the
PortChannel, regardless of the number of links in a PortChannel.
With source-based hashing, a MAC address can move between interfaces under the following conditions:
The virtual machine moves to a new Microsoft Hyper-V A link fails, causing recalculation of the hashing.
●
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 45 of 48