Cisco Nexus 7000 Series 설치 매뉴얼 - 페이지 9

{카테고리_이름} Cisco Nexus 7000 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Nexus 7000 Series 18 페이지. Switch chassis
Cisco Nexus 7000 Series에 대해서도 마찬가지입니다: 참조 매뉴얼 (2 페이지), 설치 지침 매뉴얼 (39 페이지), 참조 (34 페이지), 구성 (8 페이지), 구성 매뉴얼 (28 페이지), 빠른 시작 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (29 페이지), 교체 지침 매뉴얼 (14 페이지), 교체 지침 매뉴얼 (21 페이지), 설치 매뉴얼 (16 페이지), 문제 해결 매뉴얼 (10 페이지)

Installation

Note

Figure 9: Configuring and Managing Hypervisor and Virtual Machines

Step 4

Configure NTP:

a) Navigate to Configuration > Software > Time Configuration.

b) Click Properties to launch the Time Configuration screen.

c) Update the Time Click Options... .

d) Select NTP Settings.

e) Click Add and type the IP address of NTP server. Repeat this step to add multiple NTP servers.

f) Click OK.

g) Select General > Start and Stop with Host.

h) Click Start button. Click OK to close the configuration screens.

Step 5

Configure network fault tolerance by using the NIC teaming feature in VMware:

a) Navigate to Configuration > Hardware > Networking.

b) Click Properties for "Standard Switch: vSwitch0," as shown in the figure below.

c) In the configuration screen vSwitch0 Properties, select the tab Network Adapters.

d) Click Add... to add the NIC that is connected to data network.

e) Follow the interactive configuration dialogs and close the configuration screens until you see two or more

NICs are added to vSwitch0, as shown in the figure below.

Note

Notice the predeployed applications listed in the inventory pane of Figure

By default, only one NIC is enabled for the Hypervisor and identified as vmnic0.

Access and Configure Hypervisor

Cisco Business Edition 7000 Installation Guide, Release 11.6