Cisco Nexus 7000 Series 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} Cisco Nexus 7000 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Nexus 7000 Series 10 페이지. Switch chassis
Cisco Nexus 7000 Series에 대해서도 마찬가지입니다: 참조 매뉴얼 (2 페이지), 설치 지침 매뉴얼 (39 페이지), 참조 (34 페이지), 설치 매뉴얼 (18 페이지), 구성 (8 페이지), 구성 매뉴얼 (28 페이지), 빠른 시작 매뉴얼 (29 페이지), 교체 지침 매뉴얼 (14 페이지), 교체 지침 매뉴얼 (21 페이지), 설치 매뉴얼 (16 페이지), 문제 해결 매뉴얼 (10 페이지)

Replacing a DIMM on an I/O Module

Step 16

Step 17

Step 18

Step 19

Step 20

Step 21

Related Documentation

Release Notes

NX-OS Configuration Guides

Replacing Memory on a Cisco Nexus 7000 Series I/O Module

Align the module to the open I/O slot in the chassis and push the module into the

slot until it makes contact with the midplane.

Simultaneously push both ejector levers inward until they come in contact with

the face of the module.

The module should be fully seated in the slot and the captive screws should be

aligned with their holes in the chassis. The EMI gasket should close the gap

between this module and the next module.

Screw in the two captive screws to the chassis and tighten them to 8 in-lb (0.9

Nm).

Reconnect the copper (1000BASE-T) and fiber-optic (SFP, SFP+, FET, and X2)

I/O modules as explained in the "Connecting an I/O Module" section of the Cisco

Nexus 7000 Series Hardware Installation and Reference Guide.

Verify that the module has 8 GB of memory by using the show system resources

command.

If you need to replace the DIMM on another Cisco Nexus 7000 Series I/O module,

repeat Steps 2 through 18.

Cisco NX-OS documentation is available at the following URL:

http://www.cisco.com/en/US/products/ps9372/tsd_products_support_series_ho

me.html

The Release Notes for upgrading the FPGA/EPLD is available at the following

URL:

http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/6_x/epld/epld_rn_

62.html

Cisco Nexus 7000 Series NX-OS Release Notes, Release 6.x

Cisco Nexus 2000 Series Fabric Extender Software Configuration Guide

78-100406-01