CAB 3014 조립 지침 매뉴얼 - 페이지 6
{카테고리_이름} CAB 3014에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB 3014 13 페이지. Front-side applicator
페이지 인쇄
2
Product Description
6
2.1
Important Features
•
The supporting air and the vacuum as well as the speed of the cylinder are adjustable. That way the applicator
can be adapted to different label materials and sizes.
•
To avoid contamination within the vacuum channels they are cleaned by air pressure pulses at the end of each
application.
•
For operation in a system the I/O interface of the printer can be used.
2.2
Technical Data
Label transfer mode
Label width
in mm for
Label height
in mm for
Compressed air pressure
Sound pressure level
Product during
labeling
Labeling onto the
product
Product height
Length of swing lever
Swing angle
Cycle time about frequency/min.
Table 1
1)
Determined with 100 mm lever length / label height / print speed 100 mm/sec.
Length of swing lever: achievable labeling position of 90° (bottom edge of label) below the Hermes + ground.
2)
HERMES Q4 / Hermes + 4
HERMES Q6 / Hermes + 6
HERMES Q4 / Hermes + 4
HERMES Q6 / Hermes + 6
fixed
in motion
from the top
sideways
from the front
from the back
variable
2)
mm
1)
Technical Data
Tamp pad
Spring loaded tamp pad
3014/16 L/R 1100
3014/16 L/R 3100
25 - 114
25 - 174
8 - 250
25 - 250
0,45 MPa (4,5 bar)
under 74 dB(A)
200/300/400
Blow pad
3014/16 L/R 2100
80 - 114
25 - 114
80 - 174
-
80 - 250
10 - 100
80 - 250
25 - 100
¢
¢
¢
¢
¢
¢
¢
0 - 90°
15
6