CAB 3016 L/R 1100 조립 지침 매뉴얼 - 페이지 10
{카테고리_이름} CAB 3016 L/R 1100에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB 3016 L/R 1100 13 페이지. Front-side applicator
페이지 인쇄
4
Operation
10
4.1
Standard Operation
Check all external connections.
Load the material. Ensure that the locking system is locked "Operator's Manual" of the printer.
Open the shutoff valve.
!
Attention!
Ensure that the pad is not covered by a label when switching on the printer-applicator system.
Otherwise the vacuum sensor may be calibrated faultily.
Switch on the printer.
i
Note!
In case the pad is outside the start position in the moment of switching on it will interrupted the procedure
and give notice an error message on the display of the printer.
If you push the button pause on the printer is receipt the error and the applicator will move into the start
position.
The Applicator is ready for work.
Press the
A synchronization feed is released. The processed labels have to be removed manually. After a few seconds the
printer carries out a short backfeed to position the front edge of the next label at the printing line.
i
Note!
This synchronizing also has to be carried out when the print job has been interrupted with the cancel key.
Synchronizing is not necessary when the print head was not lifted between print jobs. This also applies if
the printer was powered off between print jobs.
Start a print job
Start the labelling process via PLC interface.
Error messages during labelling process are shown in the display of the printer Error Messages.
4.2
Cleaning
!
Attention!
Never use solvent and abrasive.
Fig. 6
respectively feed at the printer.
Cleaning pad with slide foil
Clean the outside surfaces with multi purpose cleaner.
In regularly function it's possible that accrue dust particles
and label splits. Remove that by a soft brush or/and a
vacuum cleaner.
Especially at slide foil (1) it's possible that fouling deposit.
To receive an ideal takeover and handling of the label
it's necessary to clean the surface of slide foil at regular
intervals.
1
10