CAB 4116 Series 운영자 매뉴얼 - 페이지 10

{카테고리_이름} CAB 4116 Series에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB 4116 Series 13 페이지. Stroke applicator

Operation

Fig. 4

Mounting applicator on printer

Attention!

Initiation, adjustments and changing of parts is to be performed by qualified service personnel only.

 Initiation/Service Manual Applicators.

Attention!

 Disconnect the printer from the power supply before mounting the applicator!

 Ensure that the printer is positioned and standing securely!

 Connect the compressed air only after mounting the applicator to the printer!

When cleaning the applicator it may need to be necessary to turn it away or even dismount it entirely.

Ensure that none of the adjustment screws or setting elements are altered to make certain that the labeling process

can continue unhindered after cleaning.

Turn away/dismount the applicator

1. To turn away the applicator loosen thumbscrew (5) and swing the applicator aside.

2. Disconnect SUB-D 15 male connector (6) from the female connector (7) of the printer.

3. Loosen screw (4) to release the locking plate (3).

4. Lift the applicator upward.

Mount the applicator

1. Hang the applicator to the printer via the hinges (1) and (2).

2. Connect SUB-D 15 male connector (6) to the female connector (7) of the printer.

3. To secure the applicator to the printer loosen screw (4) and move the locking plate part (3) under the hinges and

tighten screw (4).

4. Swing the applicator to the printer and tighten the thumbscrew (5).