Cisco ON100 Network Agent 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Cisco ON100 Network Agent에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ON100 Network Agent 15 페이지. Network agent
Cisco ON100 Network Agent에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (15 페이지)

페이지 인쇄

Mounting the OnPlus Network Agent

You can place the OnPlus Network Agent on a desktop or mount it on a

wall.

Placement Tips

• Ambient Temperature—To prevent the OnPlus Network Agent from

overheating, do not operate it in an area that exceeds an ambient

temperature of 104°F (40°C).

• Air Flow—Be sure that there is adequate air flow around the unit.

When placing the OnPlus Network Agent on a desktop, make sure that the

surface is flat.

Wall Mounting

The OnPlus Network Agent does not come with a wall-mount kit. For wall

mounting, you will need:

• Two self-tapping screws, each with an outer thread diameter of 3.5 mm

and a length of 16 mm.

• The outer thread diameter must not be greater than 3.7 mm, the head

diameter must be between 6.0 mm and 7.5 mm, and the head height

must not exceed 1.9 mm.

Insecure mounting can damage the device or cause injury.

ARNING

Cisco is not responsible for damages incurred by insecure

wall mounting.

To mount the OnPlus Network Agent to a wall:

• Drill two mounting holes 3.74 inches (95 mm) apart horizontally.

• Attach the two self-tapping screws to the wall.

Each screw should be mounted so that the space between the wall

and the underside of the screw head is at least 0.209 inches (5.3 mm).

• Slide the OnPlus Network Agent into position until the screws fit snugly

into the holes on the bottom of the unit.

Cisco ON100 Network Agent Quick Start Guide