Cisco ON100 Network Agent 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} Cisco ON100 Network Agent에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ON100 Network Agent 15 페이지. Network agent
Cisco ON100 Network Agent에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (15 페이지)

페이지 인쇄
Cisco ON100 Network Agent 빠른 시작 매뉴얼
Connecting the OnPlus Network Agent to
4
the LAN at the Customer Premises
At the customer premises, follow these steps to connect the
OnPlus Network Agent to the LAN.
Plug one end of the supplied RJ-45 Ethernet cable into the LAN
S
1
TEP
port on the back panel of the OnPlus Network Agent.
Plug the other end of the Ethernet cable into a LAN port on the
S
2
TEP
network at the customer premises.
The port can be either PoE or non-PoE.
Cisco strongly recommends using Category 5e or better
N
OTE
cable for gigabit connectivity. When connecting the OnPlus
Network Agent to the customer LAN, do not exceed the maximum
cabling distance of 328 feet (100 meters).

Applying Power

5
To apply power to the OnPlus Network Agent, follow these steps.
If you are using the external power adapter that is shipped with the
S
1
TEP
OnPlus Network Agent, perform these steps:
•
Connect the external power adapter to the POWER connector
that is located on the back of the OnPlus Network Agent.
•
Insert the plug that corresponds to the region of installation into
the power adapter and plug it into a power receptacle.
Plugs are included for North America, Europe, the United
Kingdom, Australia, and New Zealand.
The OnPlus Network Agent can be simultaneously connected
N
OTE
to a PoE port and to an external power source. If one of these power
sources fails, the other one will continue to supply power.
6
Cisco ON100 Network Agent Quick Start Guide