Cisco ONS 15600 카드 설정 변경 - 페이지 4

{카테고리_이름} Cisco ONS 15600에 대한 카드 설정 변경을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ONS 15600 14 페이지. Install the bay and backplane connections
Cisco ONS 15600에 대해서도 마찬가지입니다: 참조 매뉴얼 (29 페이지), 매뉴얼 (10 페이지), 참조 매뉴얼 (22 페이지), 설치 지침 매뉴얼 (14 페이지)

페이지 인쇄

NTP-E150 Change the Optical Line Rate

Click OK. The row on the Pluggable Ports pane turns light blue until the actual SFP is installed and then

Step 9

the row turns white.

Stop. You have completed this procedure.

NTP-E150 Change the Optical Line Rate

Purpose

Tools/Equipment

Prerequisite Procedures

Required/As Needed

Onsite/Remote

Security Level

Complete the

Step 1

Click the Alarms tab:

Step 2

In node view, double-click the ASAP card where you want to edit the PPM port rate.

Step 3

Click the Provisioning > Pluggable Port Modules tabs.

Step 4

Click the port with the port rate you want to change in the Pluggable Ports pane. The highlight changes

Step 5

to dark blue.

Click Edit. The Edit Port Rate dialog box appears.

Step 6

In the Change To field, use the drop-down menu to select the new port rate and click OK.

Step 7

Click Yes on the Confirm Port Rate Change dialog box.

Step 8

Stop. You have completed this procedure.

Cisco ONS 15600 Procedure Guide, R5.0

11-4

This procedure changes PPM port rates for the ASAP card. Perform this

procedure if you want to change the port rate on a multi-rate SFP that is

already provisioned.

None

NTP-E157 Provision a Multirate PPM, page 11-2

As needed

Onsite or remote

Provisioning or higher

"DLP-E26 Log into CTC" task on page 16-39

Verify that the alarm filter is not turned on. See the

page 17-50

as necessary.

Verify that no unexplained conditions appear on the network. If unexplained conditions appear,

resolve them before continuing. Refer to the Cisco ONS 15600 SONET Troubleshooting Guide.

Complete the

"DLP-E76 Export CTC Data" task on page 16-98

information.

Chapter 11

to log into an ONS 15600 on the network.

"DLP-E157 Disable Alarm Filtering" task on

to export alarm and condition

Change Card Settings

February 2008