Cisco RV130 빠른 시작 매뉴얼 - 페이지 7
{카테고리_이름} Cisco RV130에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco RV130 13 페이지. How to reboot and reset to factory default settings
Cisco RV130에 대해서도 마찬가지입니다: 기능 및 사양 (4 페이지), 빠른 매뉴얼 (3 페이지)
페이지 인쇄
Connecting the Equipment
3
You must connect a PC to the device by using an Ethernet cable to perform
the initial configuration. After the initial configuration, administrative tasks
can be performed through the network or by using a wireless connection.
To connect a PC to the device for initial configuration:
Power off all equipment, including the cable or DSL modem, the PC,
S
1
TEP
and the device.
Use an Ethernet cable to connect your cable or DSL modem to the
S
2
TEP
WAN port on your device.
Connect another Ethernet cable from one of the LAN (Ethernet)
S
3
TEP
ports to the Ethernet port on the PC.
Power on the cable or DSL modem and wait until the connection is
S
4
TEP
active.
Connect the power adapter to the device's 12VDC port.
S
5
TEP
Use only the power adapter that is supplied with your device.
C
AUTION
Using a different power adapter could damage the device.
The POWER button is on by default. The power light on the front
panel is solid green when the power adapter is connected
properly and the device has finished booting.
Plug the other end of the adapter into an electrical outlet. Use the
S
6
TEP
plug (supplied) specific to your country.
Continue with the instructions in the
S
7
TEP
configure the device.
Cisco RV130/RV130W Mutlifunction VPN Router
Using the Setup Wizard
to
7