Cisco RV345P 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Cisco RV345P에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco RV345P 13 페이지.

USB 1 and USB 2

Reset

For the RV345 and RV345P, LEDs are built into the magnetic jacks

OTE

for the LAN and WAN Ethernet ports. The left is the LINK/ACT and the

right is GIGABIT.

Back Panel

POWER—Toggles power to the device on or off.

12VDC (2.5A) or 54VDC (2.78A)—Power port that connects the device to

the provided 12VDC, 2.5 or 54VDC 2.78 amp power adapter.

Console Port—The router console port is designed for a serial cable

connection to a terminal or a computer that is running a terminal emulation

program.

USB 2—Type A USB port that supports flash drives and 3G/4G/LTE USB

dongles. Caution: Use only the power supply provided with the device;

using other power supplies may cause the USB dongle to fail.

Kensington Lock Slot - Lock slot on the right side to secure the device

physically, using the Kensington lock-down equipment.

Cisco RV345/RV345P Router Quick Start Guide

Off when no USB device is connected, or is

inserted but not recognized.

Solid green when the USB dongle is connected

to the ISP successfully. (IP address has been

assigned); USB storage is recognized.

Flashing green when sending or receiving data.

Solid amber when the USB dongle is recognized

but fails to connect to ISP (no IP address is

assigned). The USB storage access has errors.

• To reboot the router, press the reset button

with a paper clip or pen tip for less than 10

seconds.

• To reset the router to factory default settings,

press and hold the reset button for 10

seconds.