Cisco SGE2000 릴리스 노트 - 페이지 8

{카테고리_이름} Cisco SGE2000에 대한 릴리스 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SGE2000 16 페이지. Nx-os fabric extender
Cisco SGE2000에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (32 페이지), 데이터시트 (5 페이지), 펌웨어 업그레이드 매뉴얼 (5 페이지), 빠른 시작 매뉴얼 (2 페이지), 구성 매뉴얼 (46 페이지)

RELEASE NOTES

Linksys One Ready Communications Solution

1 February 2007

Auto-negotiation advertisement is also supported. Port advertisement allows the system administrator to

configure the port speeds advertised.

Manual Port Control and Identification

While port settings can be derived automatically, as described above, many settings can be set by the

user manually.

MAC Address Supported Features

MAC Address Capacity Support

This device supports up to 8K MAC addresses. It reserves specific MAC addresses for system use.

Static MAC Entries

MAC entries can be manually entered in the Bridging Table, as an alternative to learning them from

incoming frames. These user-defined entries are not subject to aging and are preserved across resets and

reboots.

Automatic Aging for MAC Addresses

MAC addresses from which no traffic is received for a given period are aged out. This prevents the

Bridging Table from overflowing.

VLAN-aware MAC-based Switching

The device always performs VLAN-aware bridging. Classic bridging (IEEE802.1D) is not performed,

where frames are forwarded based only on their destination MAC address. However, a similar

functionality may be configured for untagged frames. Frames addressed to a destination MAC address

that are not associated with any port are flooded to all ports of the relevant VLAN.

MAC/IP Address to Port View

Displays the MAC addresses and IP addresses that are associated with a given port. For each port, it is

possible to display the MAC addresses and IP addresses that are associated with that port. The

information is based on information available in the ARP table, but is presented differently.

Layer 2 Features

IGMP Snooping

IGMP Snooping examines IGMP frame contents when they are forwarded by the device from work

stations to an upstream Multicast router. From the frame, the device identifies work stations configured

for Multicast sessions and identifies which Multicast routers are sending Multicast frames.

Port Mirroring

Port mirroring monitors and mirrors network traffic by forwarding copies of incoming and outgoing

packets from a monitored port to a monitoring port. Users specify which target port receives copies of all

traffic passing through a specified source port.

Linksys One Ready Communications Solution SFE2000/SFE2000P and SGE2000/

SGE2000P