CAB MAESTRO 2M 운영자 매뉴얼 - 페이지 11
{카테고리_이름} CAB MAESTRO 2M에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB MAESTRO 2M 15 페이지. Pcb separator
페이지 인쇄4
Operation
4.4
Error Treatment
The device has an overload protection which will switch the motor off.
Error Message
Display "F"
Table 3
Error messages
1
4
Fig. 8
Alignment of blades and guides
Attention!
!
In order to ensure that the machine functions correctly, it is important that the surfaces of all parts shown
in the figure, ie. lower guide (6), upper guide (3), and the upper and lower blade covers (1,4) are exactly in
line with the blades (2,5). This setting is achieved ex-works by placing washers between the machine frame
and the parts listed.
Only dismantle the above parts when absolutely necessary.
In such an event (eg. as a result of a very narrow side-strip removed from a PCB becoming jammed),
it is important that all washers removed are carefully put to one side. Upon reassembling the machine,
mount all parts with the concerning washers at the correct positions.
Cause
Overload
•
when trying to cut beside the pre-
scored groove
•
when a component on a PCB are
jammed between the blades
2
3
5
6
Remedy
The cutter drive will perform a short backward
movement and will then switch off within 0.5 s of
the overload occurring. The backward movement
relieves the removing of the jammed material.
Remove the jammed material.
Press the Start/Stop key.
The device switches to the standby mode
(Display "0").
Check both blades for any possible damage
before re-starting operation.
11