CAB MAESTRO 3E/600 운영자 매뉴얼 - 페이지 11

{카테고리_이름} CAB MAESTRO 3E/600에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB MAESTRO 3E/600 14 페이지. Pcb separator

Installation

3.8

Adjustment of Table and Platform

1 2

Fig. 9

Adjustment of Table and Platform

Adjust the height of table (3) and platform (4) as follows :

1. Loosen screws (1).

2. Move table (3) or platform (4) in the holes (2).

3. Tighten screws (1).

Warning!

Risk of hand injury !

 Wear protective gloves while PCB separating.

Notice!

When using the device for the first time, degrease the blades with a soft cloth.

Fig. 10

Separating the PCB's

1. Move the blade carrier (2) to either the extreme front or rear end position.

2. Lay the PCB (4) onto the lower blade (5) so that the pre-scored groove in the PCB locates onto the blade edge.

The PCB is held in the horizontal position by hand.

3. To separate the PCB, the blade carrier with the upper blade (1) is drawn or pushed across the PCB with the

handle (3).

1 2