Actuonix L16-SS-GG-VV-P 사용자 구성 매뉴얼 - 페이지 3

{카테고리_이름} Actuonix L16-SS-GG-VV-P에 대한 사용자 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Actuonix L16-SS-GG-VV-P 9 페이지. Usb control and configuration of the linear actuator control board

페이지 인쇄

Apply power to the LAC board. If using the RC connector, do not connect a separate

power supply. This can result in large currents flowing between power supplies. If you

do wish to connect a separate supply, ensure the Red RC wire is disconnected.

+/- Power terminals

RC connector : No other power

You system should now operate normally with Actuonix's default configuration.

Actuonix LAC : Battery Powered, L12-P Actuator, Potentiometer Controlled

To manually adjust the LAC configuration, rotate the four potentiometers on the LAC to

the desired locations. Counter clockwise reduces the corresponding value, while

clockwise rotation increases the value. Power must be cycled before changes take effect.

Limits –

The Potentiometer closer to the USB connector is the retract limit, and the one

further away is the extend limit. For maximum stroke, set each potentiometer to fully

clockwise. Rotating counter clockwise from this position will move the limits inward,

from either end. If your settings overlap, the actuator will not move at all.