Cisco Small Business Pro SRP527W 빠른 시작 매뉴얼 - 페이지 9
{카테고리_이름} Cisco Small Business Pro SRP527W에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Small Business Pro SRP527W 17 페이지. Dot (digital office technology)
Cisco Small Business Pro SRP527W에 대해서도 마찬가지입니다: 사용자 설명서 (27 페이지), 사용자 설명서 (21 페이지)
페이지 인쇄
Do not stack or place anything on top of the SRP, or install it on
C
AUTION
a hot surface.
Desk Placement
To mount the SRP on a desktop, place the device horizontally on a flat
surface so it sits on its four rubber feet.
Wall Mounting
Position the SRP so that the back panel faces upward to reduce
N
OTE
strain on the cable connections.
Secure two number-six pan-head tapping screws, 3/4-inch (19 mm)
S
1
TEP
in length, 150 mm apart into a wall for horizontal orientation or
108 mm for vertical orientation, with the space between the
underside of each screw head and the surface of the wall equal to
5/32 inch (4mm).
For drywall installation, secure the screws by using two
C
AUTION
hollow-wall anchors (1/8 inch with 5/16-inch drill bit, or M3
with 8-mm drill bit). Without proper anchoring, the strain of
the network cable connections could pull the SRP from
the wall.
Locate the mounting screw slots on the bottom of the SRP, and
S
2
TEP
then hang it on the screws.
Connecting the Equipment
4
For Ethernet WAN connections, connect one end of the Ethernet
S
1
TEP
cable to your Internet access device (typically a modem), and
connect the other end of the cable to the WAN port.
For ADSL connections, connect your DSL cable directly to the DSL
port on your SRP526W or SRP527W. Make sure that you use an
ADSL splitter, if required by your Service Provider.
Cisco SRP500 Services Ready Platforms Quick Start Guide (SRP520 Models)
9