CAB EOS5 서비스 매뉴얼 - 페이지 9

{카테고리_이름} CAB EOS5에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB EOS5 20 페이지.
CAB EOS5에 대해서도 마찬가지입니다: 운영자 매뉴얼 (15 페이지)

Replacing Assembly Units

2.4

Removing the Casing

Fig. 3

Removing the cover

 Lift the cover (1) by turning by 60°.

 Push the cover out of the hinges (2) of the cover plate (3) diagonally to the ground.

Note!

For service work it is recommended to remove the casing consisting of cover (1) and cover plate (3)

connectedly. It is not necessary to separate the cover from the cover plate.

Danger!

Risk of death via electric shock!

 Before opening the housing cover, disconnect the device from the mains supply and wait at lease one

minute until the power supply unit has discharged.

Removing the casing

 Open the cover (1).

 Loosen 2 screws (5).

 Push the cover plate (3) with the cover (1) to the connector side.

 Lift the cover plate (3) with the cover (1) from the printer.

Mounting the casing

 Insert the hooks (4) into the slot of the bottom and push the casing to the control panel side.

 Fix the cover plate with 2 screws (5).

Fig. 4

Removing / mounting the casing