CAB 5540750 운영자 매뉴얼 - 페이지 12
{카테고리_이름} CAB 5540750에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB 5540750 14 페이지. External rewinder
페이지 인쇄
12
5
Operation
5.2
Rewinding onto 40 mm (1.6 in) Cardboard Core
i
Notice!
Make sure that the spring (1) is mounted on the rewind axle (2)!
Consider that the cardboard core (3) should be about 1 mm (0.04 in) broader than the label strip
Warning!
!
Risk of injury by rotating engine parts.
When switching on the Rewinder starts immediately and winds to the material is tightened.
6
Figure 9
1
2
3
2 3
7
8
Rewinding onto 40 mm
(1.6 in) cardboard core
(drawing below without plate)
4
5
1. Put the cardboard core (3) on the rewind axle (2).
i
Notice!
Consider the required direction of rewinding :
- The broken line is valid for inside wound labels.
- The full line is valid for outside wound labels.
2. Feed the label strip over the guide axle (8) and under the
roller (7) up to the cardboard core (3).
3. Affix the end of the label strip with consideration of the
selected rewinding direction to the cardboard core using
adhesive tape or label.
4. Slide the plate (5) with the knurled screw outward onto the
rewind axle until it stops.
i
Notice!
When using small labels it is possible that the
cardboard core not covers the spring over the
whole length. In this case the groove on the plate
must be aligned so that it fits on the spring of the
rewind axle.
5. Tighten the knurled screw (4) on the plate.
6. Switch on the rewinder on the power switch.
12