CAB 6114 L 조립 지침 매뉴얼 - 페이지 16

{카테고리_이름} CAB 6114 L에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB 6114 L 19 페이지. Air-jet box

Operation

In order to get the perfect label application it is necessary to set the jets of the applicator to the size and shape of the

used label.

Ideally the settings will have been set by the manufacturer with predetermined labeling material.

Should this not be possible the following steps will assist with the initiation and/or adjustments.

6.2

Sizing the Former Plate

Take a former plate from the accessories kit.

7 8 8

Fig. 13

Former plate

Fig. 14

Cutting the aperture

Fig. 15

Slide in the former plate

dimensions in mm

...

Etikett

1. Place the label on the former plate. Use the front

and a side edge as orientation.

2. Mark the label size on the on thefomer plate.

3. Cut the next inside perforation..

The aperture must be smaller the the label.

4. Slide the former plate complete into the blow

module. The aperture must be on the base plate

side.