CAB 6114 Series 조립 지침 매뉴얼 - 페이지 15

{카테고리_이름} CAB 6114 Series에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB 6114 Series 19 페이지. Air-jet box

Operation

 Check all external connections.

 Load the material. Ensure that the locking system is locked  "Operator's Manual" of the printer.

 Open the shutoff valve.

 Switch on the printer.

 Press the

A synchronization feed is released. The processed labels have to be removed manually. After a few seconds the

printer carries out a short backfeed to position the front edge of the next label at the printing line.

Note!

This synchronizing also has to be carried out when the print job has been interrupted with the cancel key.

Synchronizing is not necessary when the print head was not lifted between print jobs. This also applies if

the printer was powered off between print jobs.

 Start a print job

 Start the labelling process via PLC interface.

Error messages during labelling process are shown in the display of the printer  Error Messages.

6.1

Attention!

Never use solvent and abrasive.

Fig. 12

Cleaning the suction plate

respectively feed at the printer.

 Clean the outer surfaces with a multi purpose cleaner.

 Especially the surface of the suction plates needs regular

cleaning as left over debris is likely to adhere to the pad

preventing an optimal label take over.