CAB ER4/210 운영자 매뉴얼 - 페이지 9

{카테고리_이름} CAB ER4/210에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB ER4/210 14 페이지. External rewinder
CAB ER4/210에 대해서도 마찬가지입니다: 운영자 매뉴얼 (14 페이지)

Start-Up

3.3

Connecting to Power Supply

The rewinder is equipped with a wide range power unit (100-240V~), so it is possible to use the printer both with a

voltage of 230V~/50 Hz and with a voltage of 115V~/60 Hz without making changes to the printer.

Warning!

Risk of injury by rotating engine parts.

Make sure the power switch (1) is in position „O" (OFF) before connecting the printer to a power supply !

When switching on the Rewinder starts immediately without or with loose material

Figure 3

Power supply

The rewinder is ready for use, if the power cable (3) supplied in the accessories is inserted into a power supply

connector (2) and the cable is contacted to a grounded outlet.

4.1

The print an dispense of the label are orientated to the center at the MACH4 printer.

The position of the rewinded labels at the external rewinder are orientated to the plate (2) side of the rewind axle.

So it's essential to adjust the external rewinder to the printer depend of label material broadness.

Figure 4

Sighting the external rewinder to the printer

label material

width

1. Separate the external rewinder (1) from connecting set.

2. Loosen knurled nut (4) .

3. Move connecting plate (3) up to the arrow are opposite the

value (in mm) of the material broadness .

4. Tighten knurled screw (4) .

5. Put the external rewinder (1) on the connecting set

( 3.2 Mount the connecting set).

6. Put in label material.