CAB ST4/M 운영자 매뉴얼 - 페이지 14

{카테고리_이름} CAB ST4/M에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB ST4/M 16 페이지. Stacker with cutter

Maintenance

The maintenance is limited to monthly cleaning of the device.

The most important is the cleaning of the cutter blades.

Caution!

Risk of injury!

 Disconnect the printer from the electrical outlet to avoid unintended cutter moves.

 Carefully handle the cutter. The cutter blades are sharp.

Figure 11

1. Open cover (1).

2. Move table (6) downwards.

3. Remove safety covers (5 /  2.4.3 on page 11) and shift the movable side plates (7) apart from each other as

far as possible ( 2.4.1 on page 10).

4. The cutter shaft can be reached trough the hole (2). If necessary turn the cutter shaft with an Allen key (2.5 mm)

and that way displace the upper blade (3).

5. Remove dust and paper particles with a soft brush or a vacuum.

6. Remove all deposits at the cutter blades (3,4) with isopropyl alcohol and a soft cloth.

Note!

When cutting through the label material instead of the label gap remains of adhesive may accumulate on

the blades. If operating in backfeed mode, such remains of adhesive may be deposited on the drive roller as

well.

 Clean often the drive roller ( Printer Operator's Manual) and the cutter blades.

7. Re-adjust the side plates and re-mount the safety covers.

8. Move the table upwards until it stops.

9. Close cover.

Cleaning the cutter