Cisco UBR7246VXR 하드웨어 설치 - 페이지 10

{카테고리_이름} Cisco UBR7246VXR에 대한 하드웨어 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UBR7246VXR 25 페이지. Universal broadband router
Cisco UBR7246VXR에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (27 페이지), 사용자 설명서 (7 페이지), 설치 매뉴얼 (28 페이지)

페이지 인쇄

Figure 5

Installing the Rack-Mount Brackets so the Front of the Chassis Is Flush with the Rack

Rack-mount bracket

Note

You cannot use the cable management bracket in this configuration.

Figure 6

Installing the Rack-Mount Brackets so the Front of the Chassis Protrudes Out of the Rack

Rack-mount bracket

Attach the Rack-Mount Brackets to the Middle of the Chassis

To install the rack-mount brackets for an open or relay-type rack-mount configurations, complete the following steps:

Step 1

Locate the threaded holes in the middle sides of the chassis.

Step 2

Align the first rack-mount bracket to the threaded holes in the right side of the chassis, as shown in Figure 7. Use either

set of four holes to align the bracket to the threaded holes in the sides of the chassis.

Step 3

Thread the four M4 x 6-mm Phillips flathead screws through the rack-mount bracket and into the side of the chassis.

Use a number 2 Phillips screwdriver to tighten the screws.

Step 4

Repeat Step 1 through Step 3 to attach the other rack-mount bracket.

Step 5

See the "Installing the Cable-Management Brackets" section on page 11 for cable management bracket instructions.

Rack-mount bracket