Cisco Universal Broadband Router Cisco uBR10012 매뉴얼 - 페이지 25
{카테고리_이름} Cisco Universal Broadband Router Cisco uBR10012에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Universal Broadband Router Cisco uBR10012 28 페이지. Ac power entry module for the universal broadband router
Cisco Universal Broadband Router Cisco uBR10012에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (38 페이지)
페이지 인쇄
Troubleshooting the PEM
Check the following to help isolate a problem with the power subsystem:
•
•
•
•
OL-24536-01
Is the Power LED on each AC PEM on (green)?
If yes, the PEM is connected to an active 240 VAC AC power source and is supplying power to
–
the chassis.
If the Power LED is not on, and if no other LEDs are on, verify that the AC power source is
–
providing valid power. If necessary, try connecting the AC PEM to another wall outlet or power
supply.
Is the Fault LED on (yellow)?
If yes, it indicates that the PEM is connected to an active 240 VAC power source but is not
–
providing power to the chassis. Check that the AC PEM is properly inserted into the chassis and
that its power switch is on.
Check the status of the AC PEM using the show environment command.
The show environment command provides accurate information on the AC PEM only when
Note
using Cisco IOS Release 12.2(4)XF1, 12.2(4)BC1a, or a later release. If using an earlier
release, the show environment command will not correctly identify the AC PEM's error
messages.
If none of the above suggestions correct the problem, the AC PEM could be faulty. Contact a service
representative for further instructions.
AC Power Entry Module for the Cisco uBR10012 Universal Broadband Router
Troubleshooting the PEM
25