Cisco vEdge 100 하드웨어 설치 매뉴얼 - 페이지 11

{카테고리_이름} Cisco vEdge 100에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco vEdge 100 22 페이지.

vEdge 100 Router

Component

Mounting ears, left and right

Wall-mount bracket

Mounting ears screws (Packet A)

Rack-mount screws (Packet B)

Lock plate and screw (Packet C)

Wall-mount screws (Packet D)

Quick Start document

Mount the vEdge 100 Router

You can mount the vEdge 100 router in one of the following ways:

• Mount the router in a 19-inch rack

• Mount the router on the wall

In addition to the accessory box, you need the following tools to mount a vEdge 100 router:

• Number 2 Phillips (+) screwdriver

• Tape measure or level

Mount the vEdge 100 Router in a Rack

You can mount the vEdge 100 router on two front posts in a 19-inch rack using simple rack mount ear

accessories. To do so:

1. Place the router chassis on the floor or on a sturdy table near the rack.

2. Verify the internal dimensions of the rack with a tape measure. The rack-mount tray is 440 mm wide and

must fit within the mounting posts.

3. Secure the left and right mounting ears to either side of the router chassis using the four screws (two on

each side) in the packet marked A.

Figure 2: Attaching the Mounting Ears to the vEdge 100 Router Chassis

Install the vEdge 100 Router

Quantity

vEdge 100 Router