Cisco WIC-1ENET - 1700 Access Routers 1port10bt Enet Wan Interface(man 구성 매뉴얼 - 페이지 17
{카테고리_이름} Cisco WIC-1ENET - 1700 Access Routers 1port10bt Enet Wan Interface(man에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WIC-1ENET - 1700 Access Routers 1port10bt Enet Wan Interface(man 25 페이지. Configuring a single-port ethernet wic on a router
페이지 인쇄
After the configuration you entered appears, you are asked whether you want to use it.
Enter yes to save the startup configuration:
Step 8
Use this configuration? [yes/no]: yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
The configuration is saved. Otherwise, enter no. The information you entered is discarded, and you can
reenter the configuration parameters.
Router Configuration Scenarios
The following examples shows a Cisco 1700 series router configured to use the Cisco WIC-1ENET.
These are sample configurations. For descriptions of the features and commands, see the configuration
guidelines on the Cisco website.
Figure 2
IP/ATM
Example PPPoE Client Configuration
Point-to-Point Protocol (PPP) over Ethernet (PPPoE) offers a familiar dial interface to subscribers over
customer premises equipment (CPE), as shown in
separate PPP sessions. It allows hosts connected to CPE to establish PPP sessions. When the router is
running PPPoE, hosts connected to the router are not required to run individual PPP sessions.
78-11422-03
interface Ethernet0
ip address x.x.x.x x.x.x.x
!
router igrp 1
redistribute connected
network x.x.x.x
network x.x.x.x
!
end
Example Configuration
Modem
DSL/Cable
Cisco
1720
12.0.0.x
WIC-1ENET
FE
Figure
2. It allows PCs connected to CPE to establish
Connecting a Cisco WIC-1ENET Card to the LAN
Router Configuration Scenarios
17