Cisco WS-C2960G-8TC-L 구성 - 페이지 15
{카테고리_이름} Cisco WS-C2960G-8TC-L에 대한 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WS-C2960G-8TC-L 30 페이지. Swtich configuration
Cisco WS-C2960G-8TC-L에 대해서도 마찬가지입니다: 사양 (2 페이지)
페이지 인쇄
Now configure the 2950-2 switch. The commands are the same, except use
the appropriate configuration information: the IP address is 192.168.1.3/24. Test
connectivity to the Host-1 PC and 2950-1 switch.
1. Click the eSwitches icon in the toolbar and choose 2950-2.
2. On the 2950-2 switch, access User EXEC mode, and then enter the
following: enable, configure terminal, interface vlan1, ip
address 192.168.1.3 255.255.255.0, no shutdown, exit,
ip default-gateway 192.168.1.1, end, copy running-
config startup-config, and show startup-config. Make sure
you configured the right IP address.
3. Test connectivity by pinging Host-1 and the 2950-1 switch: ping
192.168.1.10 and ping 192.168.1.2. The pings should be
successful.
Now configure the 2950-3 switch. The commands are the same, except use
the appropriate configuration information: the IP address is 192.168.3.2/24. Test
connectivity to the 2600-1 and Host-4.
1. Click the eSwitches icon in the toolbar and select 2950-3.
2. On the 2950-3 switch, access User EXEC mode, and then enter the
following: enable, configure terminal, interface vlan1, ip
address 192.168.3.2 255.255.255.0, no shutdown, exit,
ip default-gateway 192.168.3.1, end, copy running-
config startup-config, and show startup-config. Make sure
you configured the right IP address.
3. Test connectivity by pinging the Host-3 and Host-4 PCs: ping
192.168.3.10 and ping 192.168.3.11. The pings should be
successful.
Now you should be comfortable with the basic configuration of the Catalyst IOS
switches.
Basic Switch Configuration
371