Cisco WS-X3011 구성 참고 사항 - 페이지 16

{카테고리_이름} Cisco WS-X3011에 대한 구성 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WS-X3011 46 페이지.

Conﬁguring the Router Card

Figure 10

Straight-through

RJ-45-to-RJ-45 cable

Conﬁguring the Router Card

This section describes how to conﬁgure the router card and contains the following topics:

•

This section provides minimum software conﬁguration information. Detailed software conﬁguration

information is available in the Cisco IOS conﬁguration guide and command reference publications.

These publications are available in the CD ROM package or you can order printed copies. Refer to

the section "Ordering Documentation" at the end of this document.

Access the Router Card Command-Line Interface

To access the router card commad-line interface (CLI), perform the following steps:

Step 1

16 Router Card (WS-X3011) Conﬁguration Note

Connecting an NT1 Device

BRI 0

ETH 0

SERIAL 0

SERIAL 1

FLEX SLOT

DIAG

BRI 0

SUPERV ISIOR ENGINE

ISDN BRI port (RJ-45)

S/T interface

Booting the Switch with the Router Card for the First Time

Conﬁguring the Router Card for the First Time

Cisco IOS Software Basics

Conﬁguring ISDN

Verifying Network Connectivity

Getting More Information

Connect a console terminal to the console port on your switch. (For more information,

refer to the "Connecting the Console" section in this document.)

SERIAL 1

AUX

WS-X3011

NT1 device

U interface

Switch