Cisco 1004 - 1004 Router 배포 매뉴얼 - 페이지 34
{카테고리_이름} Cisco 1004 - 1004 Router에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1004 - 1004 Router 40 페이지. Lightweight access points
Optional Minimal Site Survey
•
•
Make sure you support the CAT-5 and power cables to remove harmful stress on the Cisco 1000 series
Note
lightweight access point connectors.
Figure 7
A. Power injector/AC power
•
Positioning a Cisco 1000 Series Lightweight Access Point at Each Planned
Location
This section assumes that you have determined the Cisco 1000 series lightweight access point locations
as described in
Refer to
instructions on how to power the Cisco 1000 series lightweight access points at each planned location.
If you are using AC extension cords, make sure you use duct tape to avoid creating trip hazards.
Caution
•
Deployment Guide: Cisco Aironet 1000 Series Lightweight Access Points
16
Contact Cisco WLAN Solution for the Cisco 1000 series lightweight access point mounting brackets
and recommended telescoping stand screws.
Use duct tape and/or cable ties to assemble the telescoping stands, Cisco 1000 series lightweight
access points, CAT-5 Ethernet cables, Ethernet power injectors, power inverter, external power
supply, battery packs, and/or extension cords as shown in the following figure.
Cisco 1000 Series Lightweight Access Point Tripod Test Assemblies
AP
CAT5 cable
Power injector
110-220 VAC
extension cord
Continue with
"Positioning a Cisco 1000 Series Lightweight Access Point at Each Planned
Location."
"Cisco 1000 Series Lightweight Access Point
"Preparing Optional Cisco 1000 Series Lightweight Access Point Tripod Test
Using the floor plans and/or maps from
Guidelines," place the Cisco 1000 series lightweight access point assemblies at or near the indicated
locations.
AP
Power
converter
cable
110-220 VAC
extension cord
External power
converter
B. Power converter/AC power
"Cisco 1000 Series Lightweight Access Point Placement
Placement."
Assemblies" for
Deployment
78-17279-01