Epson V11H128020 - PowerLite S1 SVGA LCD Projector 제품 정보 매뉴얼 - 페이지 14
{카테고리_이름} Epson V11H128020 - PowerLite S1 SVGA LCD Projector에 대한 제품 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson V11H128020 - PowerLite S1 SVGA LCD Projector 15 페이지. Epson powerlite elpmbuni: installation guide
Epson V11H128020 - PowerLite S1 SVGA LCD Projector에 대해서도 마찬가지입니다: 사양 (2 페이지), 빠른 설정 매뉴얼 (7 페이지), 설치 매뉴얼 (19 페이지)
페이지 인쇄
Follow these steps to replace the lamp:
1. Turn off the projector, let it cool down, and unplug the
power cord.
2. Allow the projector to continue cooling for at least one hour
(if it has been on).
3. Turn the projector upside-down. Push in the tabs on the
lamp cover and push it up to remove it.
4. Use a screwdriver to loosen the two screws securing the
lamp; you can't remove the screws.
5. Remove the lamp.
EPSON PowerLite S1 Projector
6. Position the new lamp correctly, then gently insert it into the
projector. Press it into place and tighten the retaining screws.
7. Insert the lamp cover tabs, then press down until the lamp
cover clicks back into place.
Caution:
Make sure the lamp cover is securely fastened; the
light flashes and the projector lamp won't turn on if the cover
is open.
8. Follow the instructions below to reset the lamp timer to zero.
Note: A new air filter is included with the lamp. If your current air
filter is old, replace it with the new one when you replace the lamp.
5/03
EPSON PowerLite S1 Projector - 13
error