Cisco 1700 series 하드웨어 설치 매뉴얼 - 페이지 42

{카테고리_이름} Cisco 1700 series에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1700 series 46 페이지. Secure firewall management center
Cisco 1700 series에 대해서도 마찬가지입니다: 규정 준수 및 안전 정보 매뉴얼 (45 페이지), 매뉴얼 (15 페이지), 구성 매뉴얼 (25 페이지), 애플리케이션 노트 (41 페이지), 하드웨어 문제 해결 (12 페이지), 개요 매뉴얼 (13 페이지), 구성 (34 페이지), 매뉴얼 (5 페이지), 빠른 시작 매뉴얼 (6 페이지)

페이지 인쇄
Cisco 1700 series 하드웨어 설치 매뉴얼
Remove and Replace a Power Supply
Figure 35: Remove the Drive Tray
1
Drive tray screws (two on each side)
Step 3
Install a new drive:
a) Place a new drive in the empty drive tray and install the four drive-tray screws.
b) With the ejector handle on the drive tray open, insert the drive tray into the empty drive bay.
c) Push the tray into the slot until it touches the backplane, and then close the ejector handle to lock the drive in place.
Remove and Replace a Power Supply
The chassis ships with two power supplies, which are redundant and hot-swappable. One is the active power
supply and the other is the standby power supply (1+1).
This chassis also supports cold redundancy. Depending on the power being drawn by the chassis, one power
supply might actively provide all power to the system while the remaining power supply is put into a standby
state. For example, if the power consumption can be satisfied by power supply 1, then power supply 2 is put
into a standby state.
Caution
Cisco Secure Firewall Management Center 1700, 2700, and 4700 Hardware Installation Guide
38
When you replace power supplies, do not mix power supply types in the chassis. Both power supplies must
be the same wattage and Cisco PID.
Installation, Maintenance, and Upgrade
2
Drive removed from drive tray