Cisco 3800 Series 구성 - 페이지 22

{카테고리_이름} Cisco 3800 Series에 대한 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3800 Series 32 페이지. Password recovery procedure
Cisco 3800 Series에 대해서도 마찬가지입니다: 데이터시트 (8 페이지), 애플리케이션 노트 (41 페이지), 문제 해결 매뉴얼 (15 페이지), 데이터시트 (20 페이지), 빠른 시작 매뉴얼 (40 페이지), 사용자 설명서 (7 페이지)

페이지 인쇄

How to Configure Radio Settings on an Access Point

DETAILED STEPS

Command or Action

Step 1

enable

Example:

Router> enable

Step 2

configure terminal

Example:

Router# configure terminal

Step 3

interface dot11Radio interface

Example:

Router(config)# interface dot11Radio 0/3/0

Step 4

beacon {period microseconds | dtim-period

period-count}

Example:

Router(config-if)# beacon period 15

Step 5

end

Example:

Router(config-if)# end

Step 6

copy running-config startup-config

Example:

Router# copy running-config startup-config

Configuring RTS Threshold and Retries on an Access Point

Perform this task to set the Request-to-Send (RTS) threshold and number of retries.

The RTS threshold determines the packet size at which the AP issues a request to send (RTS) before

sending the packet. A low RTS Threshold setting can be useful in areas where many client devices are

associating with the access point, or in areas where the clients are far apart and can detect only the AP

and not each other. You can enter a setting ranging from 0 to 2347 bytes.

Maximum RTS Retries is the maximum number of times the AP issues an RTS before stopping the

attempt to send the packet over the radio. Enter a value from 1 to 128.

The default RTS threshold is 2312, and the default maximum RTS retries setting is 32.

Configuring Radio Settings on an Access Point

Purpose

Enables privileged EXEC mode.

Enter your password if prompted.

•

Enters global configuration mode.

Enters configuration mode for the radio interface.

The interface argument is in module/slot/port format,

•

except for the Cisco 800 series and Cisco 1800 series

fixed-configuration routers, where the interface

argument is either 0 or 1.

The 2.4-GHz radio is port 0, and the 5-GHz radio is

•

port 1.

Specifies how often the beacon contains a Delivery Traffic

Indicator Message (DTIM).

Returns to privileged EXEC mode.

(Optional) Saves your entries in the configuration file.