Cisco 3800 Series 구성 - 페이지 7

{카테고리_이름} Cisco 3800 Series에 대한 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3800 Series 32 페이지. Password recovery procedure
Cisco 3800 Series에 대해서도 마찬가지입니다: 데이터시트 (8 페이지), 애플리케이션 노트 (41 페이지), 문제 해결 매뉴얼 (15 페이지), 데이터시트 (20 페이지), 빠른 시작 매뉴얼 (40 페이지), 사용자 설명서 (7 페이지)

페이지 인쇄
Cisco 3800 Series 구성
Configuring Radio Settings on an Access Point
4.
5.
6.
7.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
interface dot11Radio interface
Example:
Router(config)# interface dot11Radio 0/3/0
Step 4
power local {cck | ofdm} {milliwatt | maximum}
or
power local {milliwatt | maximum}
Example:
Router(config-if)# power local 20
power local {cck | ofdm} {milliwatt | maximum}
or
power local {milliwatt | maximum}
power client {milliwatt | maximum}
end
copy running-config startup-config
How to Configure Radio Settings on an Access Point
Purpose
Enables privileged EXEC mode.
•
Enter your password if prompted.
Enters global configuration mode.
Enters radio interface configuration mode.
•
The interface argument is in module/slot/port format,
except for the Cisco 800 series and Cisco 1800 series
fixed-configuration routers, where the interface
argument is either 0 or 1.
The 2.4-GHz radio is port 0, and the 5-GHz radio is
•
port 1.
(Optional) Specifies the local transmit power level, which
reduces the radio cell size and interference between cells,
on a 2.4-GHz, 802.11b/g radio.
or
Specifies the local transmit power level on a 5-GHz,
802.11a radio.
On the 2.4-GHz radio, you can set CCK and OFDM
•
power levels. On the 5-GHz radio, these keywords are
not supported.
•
For the 802.11b/g radio, the milliwatt argument can be
7, 10, 13, 15, 17, or 20. For the 802.11a radio, the
milliwatt argument can be 4, 7, 10, 13, or 16.
Use the maximum keyword to specify the maximum
•
power level. This is the default setting.
7