Cisco 500 Series 매뉴얼 - 페이지 12

{카테고리_이름} Cisco 500 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 500 Series 24 페이지. Stackable managed switches
Cisco 500 Series에 대해서도 마찬가지입니다: 안전 정보 매뉴얼 (42 페이지), 매뉴얼 (4 페이지), 빠른 시작 Quide (13 페이지), 빠른 시작 매뉴얼 (21 페이지), 데이터시트 (5 페이지), 사용자 설명서 (4 페이지), 사용자 설명서 (6 페이지), 사용자 설명서 (46 페이지), 매뉴얼 (40 페이지), 관리 매뉴얼 (48 페이지), 문제 해결 및 유지 관리 (15 페이지), 빠른 참조 매뉴얼 (7 페이지), 빠른 시작 매뉴얼 (25 페이지)

Connect a Standard Headset

You can use a standard headset with your desk phone. Standard headsets plug into the headset jack on the

back of the phone with an RJ-type connecter.

Figure 10: Standard Headset Connection

Caution

Failure to press the cable into the channel in the phone can damage the printed circuit board inside the phone.

The cable channel reduces the strain on the connector and the printed circuit board.

Procedure

Plug the headset into the headset jack on the back of the phone. Press the cable into the cable channel.

Connect a Cisco Standard Base with the Y-Cable

You can connect the standard base to your phone with the included Y-cable. But note that the Y-cable has

two RJ-type connectors - one for the auxiliary or AUX port, and one for the headset port. You can distinguish

between the two connectors by their size, as the AUX port connector is slightly larger than the headset port

connector.

Caution

Failure to press the cable into the channel in the phone can damage the printed circuit board inside the phone.

The cable channel reduces the strain on the connector and the printed circuit board.

Procedure

Step 1

Plug the smaller connector into the headset jack that is located on the back of the phone. Press the cable into

the cable channel.

Accessories