Cisco 700 series 시작하기 매뉴얼 - 페이지 8

{카테고리_이름} Cisco 700 series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 700 series 27 페이지. Using profiles
Cisco 700 series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (8 페이지), 개요 (19 페이지), 사용자 설명서 (9 페이지), 관리 매뉴얼 (36 페이지)

페이지 인쇄

Preparing the Access Point

Before you mount and deploy your access point, we recommend that you perform a site survey (or use the site planning tool) to

determine the best location to install your access point.

You should have the following information about your wireless network available:

• Access point locations.

• Access point mounting options: below a suspended ceiling, on a flat horizontal surface, or on a desktop.

You can mount the access point above a suspended ceiling but you must purchase additional mounting hardware:

Note

See

"Mounting the Access Point" section on page 10

• Access point power options: power supplied by the recommended external power supply (Cisco AIR-PWR-B), a DC power

supply, PoE from a network device, or a PoE power injector/hub (the Cisco-recommended injector is the AIR-PWRINJ5=),

usually located in a wiring closet.

Access points mounted in a building's environmental airspace must be powered using PoE to comply with safety

Note

regulations.

Cisco recommends that you make a site map showing access point locations so that you can record the device MAC addresses

from each location and return them to the person who is planning or managing your wireless network.

Installation Summary

Installing the access point involves these operations:

• Performing a pre-installation configuration (optional)

• Mounting the access point

• Grounding the access point

• Deploying the access point on the wireless network

Performing a Pre-Installation Configuration

The following procedures ensure that your access point installation and initial operation go as expected. A pre-installation

configuration is also known as priming the access point. This procedure is optional.

Performing a pre-installation configuration is an optional procedure. If your network controller is properly configured,

Note

you can install your access point in its final location and connect it to the network from there. See the

Access Point on the Wireless Network" section on page 10

Pre-Installation Configuration Setup

The pre-installation configuration setup is shown in

for additional information.

for details.

Figure

"Deploying the