Cisco 7200 VXR Series 빠른 시작 매뉴얼 - 페이지 17

{카테고리_이름} Cisco 7200 VXR Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7200 VXR Series 48 페이지. Preparing for installation
Cisco 7200 VXR Series에 대해서도 마찬가지입니다: 데이터시트 (12 페이지), 매뉴얼 (14 페이지)

페이지 인쇄

Figure 12

Installing the Chassis Ground Connection

Chassis ground connector

Grounding lug

Install the Chassis Ground

Note

The grounding lug and Phillips screws are not available from Cisco Systems. Get the grounding lug from an

electrical-connector vendor and the screws from a hardware vendor. See Page 4 for the parts needed.

Step 1

Locate the chassis ground connector (1) on the rear of your router chassis.

Step 2

Insert the two screws (3) through the holes in the grounding lug (2).

Step 3

Ensure that the grounding lug does not interfere with other router hardware, such as power supplies or the network

processing engine (NPE) or network services engine (NSE).

Step 4

Use the Number 2 Phillips screwdriver to carefully tighten the screws until the grounding lug is held firmly to the

chassis. Do not overtighten the screws.

Step 5

Use the wire stripper to strip one end of the 6-AWG wire approximately 0.75 inches (19.05 mm).

Step 6

Insert the 6-AWG wire (4) into the wire receptacle on the grounding lug.

Step 7

Use the crimping tool to carefully crimp the wire receptacle around the wire; this step is required to ensure a proper

mechanical connection.

Step 8

Connect the opposite end of the grounding wire to the appropriate grounding point at your site to ensure an adequate

chassis ground.

NETWORK PROCESSING ENGINE-300

Screws

Wire