Epson V11H274020 - PowerLite 1825 XGA LCD Projector 사용자 설명서 - 페이지 8
{카테고리_이름} Epson V11H274020 - PowerLite 1825 XGA LCD Projector에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson V11H274020 - PowerLite 1825 XGA LCD Projector 14 페이지. User replaceable parts list
Epson V11H274020 - PowerLite 1825 XGA LCD Projector에 대해서도 마찬가지입니다: 사용자 설명서 (42 페이지), 운영 매뉴얼 (36 페이지), 빠른 설정 (2 페이지), 운영 매뉴얼 (47 페이지), 제품 사양 (2 페이지), 부품 목록 (1 페이지)
페이지 인쇄
PowerLite 1825
Using the Remote Control
When using the remote control, stand within 20 feet (6 meters)
of the projector. Point the remote control either at the projector
or at the screen (the projector's front sensor can detect signals
bounced off the screen). Press the button for the function you
want to use. Avoid using the remote under bright fluorescent
lamps or in direct sunlight, or the projector may not respond
properly.
Switching Between Picture Sources
If your projector is connected to more than one computer
and/or video source, you can switch between the different
sources:
❏ The easiest way to select your source is to press the
button on the remote control (or the
button on the projector) repeatedly until you see the image
you want on the screen.
❏ On the remote control, there are several
Use them to switch between equipment connected to the
port identified on each button, or to use EasyMP.
After you select a source, the screen goes dark for a moment
before the image appears.
Turning Off the Picture and Sound
You can temporarily turn off the image and sound when you
want to redirect your audience's attention. There are two ways
to do this:
❏ Press the
button on the remote control. This
A/V Mute
turns the image off and stops the sound. To turn the image
and sound back on, press the button again.
8
Search
Source Search
buttons.
Source
2/08
❏ Close the A/V mute slide, as shown below:
Stopping Action
To stop the action and keep the current image on the screen,
press the
button. The sound continues.
Freeze
Note: This function pauses the image, not the sound. Because the
source continues to transmit signals, when you resume the action, it
won't be at the point you stopped it.
To restart it, press the
Freeze
Zooming Part of Your Image
You can zoom in on a portion of the image using the
buttons on the remote control.
1. Press the
button on the remote control.
E-Zoom
You see a crosshair indicating the center of the zoom-in
area.
2. Use the
pointer button to position the crosshair.
3. Continue pressing the
E-Zoom
selected area up to 4 times.
4. While the image is enlarged, you can:
❏ Use the
pointer button to move around the screen.
❏ Press the
E-Zoom
5. When done, press the Esc button to return the image to its
original size.
button again.
E-Zoom
button to enlarge the
button to zoom out.