Cisco 800 Series 릴리스 정보 - 페이지 12
{카테고리_이름} Cisco 800 Series에 대한 릴리스 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 800 Series 36 페이지. Fast step software design guide
Cisco 800 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (13 페이지), 빠른 시작 매뉴얼 (17 페이지), 구성 (32 페이지), 디자인 매뉴얼 (50 페이지)
페이지 인쇄
New and Changed Information
dial-peer voice 1 pots
destination-pattern 5551111
port 1
no call-waiting
ring 0
volume 4
dial-peer voice 2 pots
destination-pattern 5552222
port 2
no call-waiting
ring 0
volume 2
Distinctive Ringing Based on Caller ID
This feature allows the user to register within the router up to twenty different numbers for each POTS
port and to assign distinctive ring cadences to each of these numbers. Three different cadences are
available. One of them is the normal ring cadence, as defined by Nippon Telegraph and Telephone
(NTT), and is the default cadence for unregistered numbers. Numbers are registered and ring cadences
are assigned with CLI commands.
This feature is similar to the Nariwake feature available by subscription from NTT. However, this feature
does not require the user to subscribe to any special service from the ISDN switch. If the user already
subscribes to Nariwake, then Nariwake will take precedence over this feature.
The ring cadences used for this feature are the same as those used by the Nariwake feature.
To enable and configure distinctive ringing based on caller ID, use the following IOS command in
dial-peer configuration mode:
caller-number number ring cadence
no caller-number number ring cadence
where number is the caller ID number of the incoming call, and cadence is the setting for ring cadence
and duration. By default, this feature is disabled.
If you have configured the maximum number of twenty per dial peer, disable the numbers by using the
no caller number ring cadence command.
The following is an example of the distinctive ringing configuration:
cisco801# configure terminal
Enter configuration commands, one per line.
cisco801#(config)#dial-peer voice 1 pots
cisco801#(config-dial-peer)#caller-number 11111 ring 1
cisco801#(config-dial-peer)#caller-number 22222 ring 2
cisco801#(config-dial-peer)#caller-number 33333 ring 1
The following is an example of the output for the distinctive ringing feature from the show
running-config command:
!
dial-peer voice 1 pots
no caller-id
no forward-to-unused-port
call-waiting
ring 0
no silent-fax
registered-caller ring 1
port 1
volume 3
caller-number 11111 ring 1
Release Notes for the Cisco 800 Series Routers for Cisco IOS Release 12.1(5)YC
12
End with CNTL/Z.
78-12776-04